TOGGLER SNAPTOGGLE BB Toggle Anchor, Zinc-Plated Steel Channel, Made in US, 3/8" to 3-5/8" Grip Range, For 1/4"-20 UNC Fastener Size (Pack of 100)
- Toggle anchor installs behind 3/8"- to 3-5/8"-thick hollow materials including gypsum board, drywall, and concrete block to provide a secure hold from within the mounting material
- Anchor affixes to the wall before adding the bolt and fixture, allowing one-person installation and fixture changes
- Made in USA, and works with 1/4"-20 UNC-threaded metal bolts (sold separately)
- Ultimate tensile strength is 265 lb. in 1/2" drywall and 1,080 lb. in concrete block with a 1/4"-20 UNC bolt
- Use one-fourth or less of listed maximum values for safe working loads (as required by local regulations)
Crystal Morandi
One of the best inventions for the workforce
One of the best inventions for the workforce, I use these for all kinds of things, and they stay in the wall, so if you need to remove the bolt, the toggle stays in place! Most of the Home Depot wanna bees are crappy, I used to only use Hilti, they still remain the best, but these are a close second!
Dan Morrison
TV Mounting in Plaster Lathe Walls - Success!
Amazing product. My house could come down, and my TV mount will remain. Used WAY too many to mount a 55" TV to my very old plaster lathe wall. HINT - Screw in with a screwdriver, NOT a power drill. I lost about 10 of them in the wall because I was getting a bit too overzealous in my drilling efforts.
Kent Hickson
Does not include the bolts.
works good. Does not include the bolts that screw into the toggle. Since my wall depths vary, I bought the lengths needed for each situation. I have secured a mounting for a 77" LED TV, a wall mounted desk, towel bars, 24" deep shelving systems, etc. Be sure to go through the metal stud for heavier anchoring as sheetrock is often not sufficient.
Sweetness Jones
I bet they love them too
If you are working commercially, these are absolutely what you should be using. They will save you money. Watch for somebody on the job site using them, it will be a small subcontractor because they are too expensive to give away, and ask him about them. I bet they love them too.
Bonnie Clyde
Perfect for mounting a solid point where needed.
Great and very innovative hardware piece here. The only real caveat is that the nylon rods MUST be exactly even of the bolt will not thread in the metal nutsert. We send these to customers for product mounting and I usually send an extra just in case and very rarely do I get any questions on their installation or difficulties.
Jef Gaspar Sabrozo
then you know this is an excellent product. Buy them in bulk here rather than ...
If you know this product, then you know this is an excellent product. Buy them in bulk here rather than small packets at the Big Box home improvement stores. You'll save a ton of money in the long run.
Travis Tmac Kemp Sr.
Magic wall Hanging Devises
These items are great!!! Will never use a regualt toggle bolt again. I hung a floating sink in a commercial bathroom with steel brackets into cinderblock with these. I used 3 in each steel bracket and when done i could jump on them. They do need to be placed in correctly, ie. straight and tight. Then just place the correct screw from myour local hardware into the treads, instant wall haning ability. Because of their strenght, I would think when placing in drywall alone have to be careful not to over tighten as you may pull them straight through. I give these an A+ rating.
John Wright
Togglers have extremely useful and easy to install The Bulk box of 100 ...
Togglers have extremely useful and easy to install The Bulk box of 100 does not include the necessary Screws/ bolts Did not know this till I was on site and started looking for the bolt bag and thats when I found out they were not included so Had to make a Trip to the Hardware store Togglers are Great If they would make two more larger sizes that would be awesome Love em
Lisa Tomlinson
The only snap toggle to use in the field. ...
The only snap toggle to use in the field. I have put in a thousand of these over the years and they never fail.
Bisma Farooq
I like the fact that you use a machine screw and ...
These anchors are so simple to use and very strong. I like the fact that you use a machine screw and can reuse the screws when you want to change something or get it wrong the first time. They are permanent so you need to place them correctly. You cannot reuse them as there is no way to remove them but that is no reason to not use them. Is this a record for using the same work in a sentence? LOL I like them.